PENECRETE MORTAR™ is used for filling cracks and covers at joints, and to fill form tie holes, honeycomb areas and routed out cracks in mortar consistency.
Penecrete Mortar is a cementitious, ready-mixed waterproof repairing and sealing mortar.
Uses
Used in conjunction with Penetron for:
- Installation of seal strips, reglets and covers at joints to assure water tightness.
- Patching of tie holes and faulty construction joints.
- Filling of routed out cracks.
- Waterproof sacking of concrete "bugholes".
- Repairing of spalled and honeycombed areas.
Benefits
- Can be skim coated or feather edged.
- Can be applied to moist concrete.
- Fast setting.
- Inorganic - no polymers.
- Non-flammable.
- Resists abrasion and mechanical wear.
- Freeze/thaw resistant.
- Certified for use in contact with potable water.
- Can be applied by hand painting, trowel or brush.
Technical Data
Note: All data values are average values obtained under laboratory conditions. Impractical use, temperature, humidity and absorbance of the substrate may influence given values.
| Size | Consumption | Yeild/Bag | ||||
| Inch | mm | lb/ft | Kg/m | ft | m | |
| Cracks, U-shaped |
1x1 | 25x25 | 1/0 | 1.3 | 50 | 15.3 |
| Reglets | 1x1 | 25x25 | 1/0 | 1.3 | 50 | 15.3 |
| Coves, Triangular |
1.5x1.5 | 38x38 | 1/0 | 1.3 | 50 | 15.3 |
| Tie Holes | 1x1x1 | 25x25x25 | - | - | ~600 nos | |
| Honeycomb patching approximately 0.4ft3 (0.011m3)/bag All above values are approximate depending on surface conditions. |
||||||
Typical projects
Penebar SW-55 can be applied to no-moving, cold joints on all concrete building projects that need protection from moisture ingress, including:
- Underground structures.
- Basements.
- Precast panels.
- Tunnels.
- New concrete onto old concrete.
- Manholes.
- Retaining walls.
- Storage tanks.
- Concrete pipe.
- Car parks, etc.
Physical Data
Aggregate State: Powder
Colour: Cement Grey
Bulk Density: 112 lbs/ft3 (1.81kg/1)
Pot Life: 30 minutes
Setting Final Approximately 2 hours
Potable Water Approved
